Page MenuHomePhabricator

Reinit after deletion
Closed, WontfixPublic


While testing we had one user who ran across the following situation:

He had several images in the datamanager (all but one with the same geometry) and had done a reinit on the odd one out.

He then proceeded to delete the odd one out image and was confused, because he could not see any other images.

We might consider to do a reinit after deletion of an image, at least if all of the remaining ones have the same geometry.

Event Timeline

Probably the same scenario:

  • Open an image with only one slice (e.g. T:\3M3 Demodaten\Measurement\0011.dcm)
  • Draw two measurements
  • Delete one measurement in the data manager

--> No image is displayed. You have to scroll into the right slice to see the image again or click on the remaining measurement in the data manager.

kislinsk added a subscriber: kislinsk.
This task was automatically closed because it wasn't updated at least since July 2016 (over 2 years). Please re-open this task if you think that it is still relevant. This most probably means that you will resolve it.