Page MenuHomePhabricator

SurfaceMapper2D does display surface contour at wrong time steps
Closed, WontfixPublic


The SurfaceMapper2D has only limited support for time-dependent rendering.

If you create a surface from a binary image at a single time step (independent which one), its 2D contour is also drawn at all other time steps in the 2D view.

On the contrary, the 3D surface mapper works fine concerning this use case. It only shows the mesh at the respective time step in the 3D render window.

Event Timeline

kislinsk claimed this task.
kislinsk added a subscriber: kislinsk.
This task was automatically closed because it wasn't updated at least since July 2016 (over 2 years). Please re-open this task if you think that it is still relevant. This most probably means that you will resolve it.